63 / 106
6 • Working with the electrosurgical unit
80113-101_V25087
2023-11
6. To save the change setting, press the top left selection button for approx.
3 seconds.
A progress indicator appears next to the selection button in the display segment.
A tick then confirms that the save process was successful.
7. If you want to change other setup settings, repeat steps 3 to 6.
8. If you want to continue using the unit after making the settings, turn the unit off
and then on again.
Change service settings
Note: The service settings are inaccessible to the user. An Erbe service engineer can
adjust/change the service settings based on your requirements.
To Next Page
Loading...
