ESAB A2 - Page 20

3 SUBMERGED ARC WELDING
0460 949 274
- 20 -
© ESAB AB 2015
Settings Setting range In steps of Value after
resetting
Start phases OFF or ON - OFF
Open-circuit voltage OFF or ON - OFF
Maximum open-circuit voltage 5 - 60 V 0.1 V 50 V
Stop data
2)
Flux post-flow 0 - 99.0 s 0.1 s 0 s
Crater filling OFF or ON - OFF
Crater filling time 0 - 10 s 0.01 s 1 s
Burnback time 0 - 10 s 0.01 s 1 s
Stop phases OFF or ON - OFF
Control parameters
Dynamics Auto or Set values - Auto
Inductance Auto or Set values - Auto
Setting limits - - -
Measure limits - - -
1)
The setting range is dependent on the product used.
2)
The menu shows the settings that belong to the selected regulation type.
3)
Applies only to Aristo1000 power sources