ESAB A2 - Tools and Utilities; Event Handling and Error Management; Event Log Details

9 TOOLS
0460 949 274
- 56 -
© ESAB AB 2015
9 TOOLS
Main menu → Tools
This menu contains the following sub-menus:
• Event handling, see “Event handling”, page56.
• Export/Import, see “Export/Import”, page59.
• File manager, see “File manager”, page60.
• Edit setting limits, see “Setting limit editor”, page63.
• Edit measure limits, see “Measure limits editor”, page63.
• Production statistics, see “Production statistics”, page65.
• Quality functions, see “Quality functions”, page65.
• Calendar, see “Calendar”, page67.
• User accounts, see “User accounts”, page67.
• Unit information, see “Unit information”, page69.
9.1 Event handling
Main menu → Tools → Event handling
Fault management codes are used to indicate that a fault has occurred in the welding
process. Indicated in the display via a pop-up menu and an exclamation mark appears in
the upper right-hand corner of the display.
Note! disappears from the display as soon as you enter the event log menu.
The Event handling menu has got two sub-menus, Event log (see “Event log”, page56)
and Active errors (see “Active errors”, page57).
9.1.1 Event log
Main menu → Tools → Event handling → Event log
All errors that arise during the use of the welding equipment are documented as error
messages in the error log. Up to 99 error messages can be saved. If the error log becomes
full, i.e. if 99 error messages have been saved, the oldest message is automatically deleted
when the next fault occurs.