TABLE OF CONTENTS
0460 949 274 © ESAB AB 2015
6.13 AC offset ............................................................................................................. 26
6.14 Flux pre-flow (SAW) ...........................................................................................26
6.15 Gas pre-flow (GMAW) ........................................................................................26
6.16 Air pre-flow (Gouging) .......................................................................................26
6.17 Start type............................................................................................................. 26
6.18 Wire creep start .................................................................................................. 27
6.19 Start phases........................................................................................................ 27
6.20 Max Open Circuit Voltage (OCV).......................................................................27
6.21 Flux post-flow (SAW) .........................................................................................27
6.22 Gas post-flow (GMAW) ......................................................................................27
6.23 Air post-flow (Gouging) .....................................................................................27
6.24 Crater filling ........................................................................................................ 28
6.25 Burnback time .................................................................................................... 28
6.26 Stop phases........................................................................................................ 28
6.27 Dynamic regulation............................................................................................ 28
6.28 Control parameters ............................................................................................ 28
6.29 Setting limits....................................................................................................... 29
6.30 Measure limits .................................................................................................... 29
7 MEMORY MANAGEMENT ................................................................................. 30
7.1 Control panel working method .........................................................................30
7.2 Store .................................................................................................................... 31
7.3 Recall................................................................................................................... 32
7.4 Delete .................................................................................................................. 33
7.5 Copy .................................................................................................................... 34
7.6 Name ................................................................................................................... 36
7.7 Edit ...................................................................................................................... 37
8 CONFIGURATION MENU................................................................................... 39
8.1 Code lock ............................................................................................................ 39
8.1.1 Lock code status .............................................................................................. 39
8.1.2 Specify/edit lock code ...................................................................................... 40
8.2 General configuration........................................................................................ 40
8.2.1 Fast mode soft keys ......................................................................................... 41
8.2.2 Quality data log to file....................................................................................... 42
8.2.3 Soft key configuration....................................................................................... 42
8.2.4 Auto save mode ............................................................................................... 44
8.3 Machine configuration....................................................................................... 44
8.3.1 Product code .................................................................................................... 44
8.3.2 Wire feed axis ..................................................................................................45
8.3.3 Cold wire axis (ICE) .........................................................................................45
To Next Page
Loading...
