IP Series IP Feature Phone operation
A.17
Headset operation
You can use your phone with a headset connected to the handset jack. You must have a headset
key programmed as one of your programmable feature keys (see “Other feature keys,” page A.33)
to be used to connect or disconnect from a call. (See also “RELEASE key,” page A.13.)The key will
blink green when a call is ringing and glow green when connected. You turn Headset Mode on or off
as part of user programming (PROG/HELP 3 3).
Outside dial tone preference
If you make mostly outside calls, you may find this setting helpful. It tells your station to connect
automatically to an available outside line; i.e., you don’t have to dial 9 (or 8 or 71–76) before the
phone number. Therefore, when you lift the handset or press SPEAKER, you will immediately
receive an outside dial tone from the highest-numbered line available to you.
5
Note: To place an internal call while in this mode, press the appropriate station key or (a.) press
TRANSFER to switch to internal dial tone and (b.) then dial the extension number.
Line keys
If some of your programmable feature keys have been programmed as line keys (or you can
program line keys using PROG/HELP 2), press an unlit key to access the line. An outside call
transferred to your station can be answered by simply lifting the handset or pressing SPEAKER. You
do not have to press the line key. The LED indications for the line keys are:
LED Line status
Glowing red In use
Green Connected to your station
Blinking red Ringing at another station
Blinking green Ringing at your station
Slowly blinking red Parked by another station
Slowly blinking green Held or parked by you
Note: Dialing 9 (or 8 or 71–76) to be assigned a line automatically is always available.
Private line
If a private line has been assigned to your station, you must have a line key programmed (see
pages A.32–A.33) in order to access it.
5
This aspect (
i.e., that it’s always the highest line available to you) can’t be changed.
To Next Page
Loading...
