IP Series Analog stations
B.9
3 Pager notification
1 Enter pager number
Enter the pager number followed by # (24 digits maximum
15
). Do not include a CO line
access code (i.e., 9, 8 or 71–76) before the number.
2 Delete pager number
Deletes the currently programmed pager number.
3 Hear current pager number
Plays back the currently programmed pager number.
4 Urgent message activation
1 Urgent messages only
Only urgent messages (see “Urgent messages,” below) will be delivered.
Note: Remember to say in your personal greeting that callers should press 2 to mark a
message as urgent. (For more on personal greetings, see page A.21.)
2 All new messages
Any new message will be delivered.
Urgent messages
You can have all new messages delivered as explained in the previous discussion or only those
marked as urgent. If you have enabled urgent messages as part of user programming, you must
include, in your personal greeting, instructions to the caller to press 2 to mark the message as
urgent. In addition, messages marked urgent will be played ahead of other new messages during
message retrieval.
9 Message Recycle Bin (un-delete)
Each user’s most recently deleted 10 messages will be stored in a Message Recycle Bin to allow
the user to recover messages that may have been deleted in error.
The most recently deleted message will be played first. Press 9 to move to the next message. Press
8 to restore the message to your mailbox as an old message.
15
If pauses or other special dialing characters are required, contact the administrator.
To Next Page
Loading...
