Patch 105
By default, doubled dimmers start with an offset network DMX address value of 20000. Therefore,
in the above example, address 1B (channel 97) is actually controlled by network DMX address
20001. Address 2B is actually controlled by network DMX address 20002 and so on. This offset
matches the default offset in CEM+ / CEM3 when configuring your Sensor dimmer rack for dimmer
doubling. To change the default offset value, see {Dim. Dbl. Offset} (on page137).
Note: For Sensor Classic racks using dimmer doubling, the offset value should be set to
256.
Note: Dimmer doubling needs to be turned on per DMX port in the ECU. See Local DMX
Outputs (on page466).
Note: There is also a Dimmer Doubling setting for Net3 Gateways with DMX outputs. This
is used with Sensor racks that are connected via DMX. The Gateway must be properly con-
figured.
Moving and Copying Channels
Channels can be moved from one location to another within patch.
[1] [Copy To] [Copy To] [2] - moves channel 1's data to channel 2. Channel 2's data is replaced
by channel 1's. Channel 1 is unpatched.
[1][Copy To] [Copy To] [2][Part][2] - creates a part 2 for channel 2 and moves channel 1's data
to the new part. Channel 2's data remains in part 1. Channel 1 is unpatched.
The second press of the [Copy To] key changes the command from Copy To into Move To.
Note: Move To always impacts the entire show.
The following options are available with [Copy To]:
[Copy To] - copies a channel to another location within patch.
[CopyTo] {Plus Show} - copies a channel to another location within patch and all record tar-
gets in the show.
[Copy To] {Only Show} - copies a channel to another location with all record targets in the
show but not the patch data.
[Copy To] {Only Text} - copies only the notes and keyword fields from one channel to another.
Swapping Channels
Channels can be swapped for each other in patch:
[1] {Swap} [2] [Enter]
This syntax will replace channel 1's data with channel 2's and vice versa in patch and throughout the
entire show.
Note: Swap always impacts the entire show.
The following options are available with {Swap}:
To Next Page
Loading...
