Storing and Using Submasters 353
Note: Macros can also be assigned as a button action. See Submaster Fader and Button
Configuration (on page349)
Triggering an Action
Pressing the bump button of a submaster will trigger any actions assigned to its execute list.
Adding a Trigger
[Sub] [1] {Execute} {Macro} [2] [Enter] - triggers macro 2 when submaster 1's bump button is
pressed.
Removing a Trigger
[Sub] [1] {Execute} {Macro} [Enter] - removes the trigger from submaster 1's execute list.
Freeze and StopEffect on Submasters
Freeze
[Fader Controls] {Freeze} can be used to halt all effect activity on any active submaster. To activate a
freeze for only a specific submaster, press [Fader Controls] {Freeze} & [Load].
There are two ways to remove the freeze command:
Press {Freeze} & [Load] again for the specific faders to unfreeze the activity.
Press [Assert] & [Load] or [Go] or [Stop/Back] for the specific faders to resume the activity.
StopEffect
The [Fader Control] {Stop Effect} button can be used to stop all effects from operating on any or all
faders, or it may be used with the control keypad to stop a specific effect.
To stop all effects on a fader, press [Fader Control] {Stop Effect} & [Load] of the associated
fader.
To stop a specific effect regardless of the fader it is operating on, press [Effect] [2] [Fader Con-
trol] {StopEffect} [Enter].
When an effect is stopped, all impact of the effect is removed and the stage output is as though the
effect had never been activated.
Moving and Copying Submasters
You can move a submaster using Move To. Press [Copy To] twice to put Move To on the command
line.
For Example:
[Sub] [2] Move To [Sub 9][Enter][Enter] - moves the contents, label, and timing data
from submaster 2 and places it in submaster 9. Submaster 2 is removed.
You can copy the contents of a submaster by using the [Copy To] button.
To Next Page
Loading...
