ETC ION - Parked Addresses in Live

Using Park 339
[2] [At] [5] [0] [Park] [Enter] - parks channel 2 intensity at 50%
[2] {Intensity} [Park] [Enter] - parks the intensity of channel 2 at its current value
[2] [Park] [Enter] - parks all parameters of channel 2 at their current settings
Note: If a channel list is constructed in which some channels are parked and some are
unparked, [Park] [Enter] will unpark them all. A confirmation will be required.
[2] [At] [Park] [Enter] - if channel 2 is unparked, this command parks intensity at the current
value. If the intensity for channel 2 is parked, this command unparks intensity.
[2] [Color Palette] [8] [Park] [Enter] - parks the color for channel 2 in color palette 8.
[Group] [Cue] [6] [Park] [Enter] - parks all the channels stored in cue 6 at their levels provided in
the cue.
[Park] [Enter] - clears all parked channels and scaled park instructions (see Scaled Parked Val-
ues in Live (below)). A confirm is required. When a channel is unparked, it reverts to the level
the console is currently providing, or its default value if there is no current instruction. A con-
firmation will be required.
You can use [Recall From] [Park] to set a channel or parameter to the same level as the current park
value. See Recall From Park (on page283) for more information.
Scaled Parked Values in Live
A scaled parked value allows the intensity output (only) to be modified proportionally in live. Scaled
park values are ignored when storing a record target. The setting on the display indicates what
should be stored, not the actual scaled value. An example of how to set a scaled parked value in live
includes:
[3] [At] [/] [1] [2] [5] [Park] [Enter] - sets a scaled value of 125% on channel 3 intensity. In other
words, whenever channel 3 is active, it will be active 25% higher than its current setting.
[3] [At] [/] [8] [5] [Park] [Enter] - sets a scaled value for channel 3. Whenever channel 3 is active,
it will playback 15% lower than its current setting.
Remove the scaled parked value:
[3] [At] [/] [Park] [Enter] - unparks a scaled intensity for channel 3.
[Park] [Enter] - unparks all parked channels.
A channel can have both a scaled parked value and a parked intensity value. Keep in mind that the
parked intensity has priority over (and overrides) scaled park values. A channel can have a parked
value or a scaled park value, but not both.
Parked Addresses in Live
DMX addresses can be parked in Live. Below are some examples of parking an address in Live:
{Address}[5] [At] [5] [0] [Park] [Enter] - parks output 5 at 50% intensity.
{Address}[5] [Park] [Enter] - unparks output 5.
{Address}[Park] [Enter] - unparks all parked outputs.