Working with a Single Cue List 251
Cue 5 is active in Live.
[Group] [1] [Focus][At] [Enter]
This command lifts the current move instructions for Group 1 focus, and recalls the focus
data for those lights from the immediately preceding cue. It is now manual, and can be
stored or updated as required.
You may use [At] [Enter] to affect only certain channels or parameters by selecting them specifically:
[2] [At] [Enter] - this will remove the changes for channel 2 only.
[2] {Color} [At] [Enter] - this will remove only the color data changes for channel 2.
[2] [Thru] [5] [+] [9] [+] [1] [1] [Thru] [1] [5] [-] [1] [2] [-] {Zoom} [At] [Enter] - removes the
changes for only the selected channels for all parameters except zoom.
Modifying Using Record
You may modify a cue by re-recording it entirely. After making changes to channels/ parameters:
[Record] [Enter] [Enter] - will replace any data in the active cue with the current stage settings.
[Record] [Cue] [x] [Enter] [Enter] - will replace the any data in cue “x” with the current stage
values.
Using selective storing will modify the existing cue without overwriting it. For more information, see
Using Selective Store (on page237)
[1] [Record] [Cue] [2] [Enter] [Enter] - will only record the changes to channel 1.
Note: Using [Record] will store all parameters of all non-default channels onstage. This
means that all other cue data and submaster data will be included in the record action. This
is a common method when working with a single cue list. When working with multiple cue
lists and/ or submasters, [Record Only] is a useful tool.
Modifying Using Record Only
Modifying existing cues using [Record Only] is considered a “selective store” function. As such, it
adds or modifies only manual data to the target cue, but leaves any other data that was already in
the cue intact and does not include playback values from other cue lists or submasters. [Record
Only] is a good way to modify existing cues without including contributions from other playbacks in
the cue. In that way, it is very similar to [Update] (below).
All of the same commands used for Record may also be used for Record Only.
[Record Only] [Enter] [Enter]- adds the current manual data to the selected cue.
[Record Only] [Cue] [x] [Enter] [Enter] - adds the current manual data to cue “x”.
[Update]
Update is a powerful feature, and also very versatile. Using a combination of [Q Only], [Track],
[Trace], and {Make Absolute}, the number of ways you can update specific information and manual
data is virtually endless. Data can be updated to various record targets either at once, or individually.
To Next Page
Loading...
