System Basics 57
The display will remain in this state until you disengage it by pressing [Flexi] again.
About & Display Toggles
While in Live/Blind, you can use the [About] key to view additional information.
When in an [About] mode, the mode type will display in the upper left hand corner of the Live/ Blind
display.
The following is a list of the [About] modes available in the Live/ Blind displays:
Note: Double press [About] & [key] to latch the mode.
[About] & [Data] - displays the background level information.
[About] & [Park] - displays the parked levels.
[About] & [Part] - displays the cue part number for each parameter.
[About] & [Cue] - displays the source target type and number. For cues, the cue list and cue
number that contained the last move will display.
[About] & [Mark] - displays the mark cue used by the channels.
[About] & [Next]/[Last] - displays the next cue with that the channels move in or the last cue
with that the channels moved in.
[About] & [Label] - displays the reference labels.
[About] & [Time] - displays the discrete time.
[About] & [Path]/{Color Path} - displays the color paths.
Note: To page while in these modes, release the second button while keeping [About] held
down.
Playback Status Display
The playback status display (PSD) allows you to view a range of cues in the current cue list, all cue
attributes for those cues, and a view of the fader configurations for 10 pages of 10 faders each (for a
total of 100 visible faders.
The PSDopens on Tab 2. This display cannot be closed, but you can have multiple instances of the
PSDopen on different tabs.
Holding down [Time] , while a cue is fading, will display the cue category times counting down in the
cue list display area. The default action is to show the total time not the countdown.
To always show the countdown, a {PSD Time Countdown} option is available in PSD configuration
menu (see Playback Status Display Configuration (on page63)). When the {PSD Time Countdown} is
enabled, the cue category times will countdown as a cue is fading. To see the total time, hold down
the [Time] key. {PSD Time Countdown} is “disabled” by default.
An optional command line for the playback status display is available. The optional command line
must be enabled to use. See Playback Status Display Configuration (on page63).
There are three formats for the playback status display on all consoles:
To Next Page
Loading...
