Storing and Using Curves 373
[Cue] [5] {Attributes} {Curve} [At] [Enter] - removes any curve from cue 5.
[Cue] [8] [Part] [3] {Attributes} {Curve} [6] [Enter] - applies curve 6 to part 3 of cue 8.
Applying a Curve To Scroller Fans
Curves can also be applied to a scroller fan. When applied to a scroller fan, the output of the fan will
be controlled by the intensity of the channel. To apply a curve to a scroller fan, go to Patch>At-
tributes>{Fan Curve}. See Scroller Fan Curves (on page114)
Delete a Curve
While in the curve display, you can delete a curve in the following ways:
[Delete] {Curve} [3] [Enter] [Enter] - deletes curve 3 from the list.
[Delete] {Curve} [9] [0] [1] [Enter] [Enter] - since curve 901 is a pre-established curve, this com-
mand will return curve 901 to its default state, thereby removing any edits to it.
[Delete] [Enter] - deletes the currently selected curve.
To Next Page
Loading...
