Using Groups 189
{InterLeave} creates a number of distributed sets of channels, that are not clustered together.
[1] [Thru] [1][2]{Chan Per Group} [4] {InterLeave} [Enter] would create these 4 sub-
groups: (1,4,7,10) (2,5,8,11) (3,6,9,12).
[1] [Thru] [5] [+] [1][1] [Thru] [1][5] [+] [2][1] [Thru] [2][5] {Chan Per Group} [3] {Inter-
Leave} [Enter] would create these 5 subgroups: (1,11,21) (2,12,22) (3,13,23) (4,14,24)
(5,15,25).
{Num Groups} creates a specified number of subgroups.
[1] [Thru] [1][2]{Num Groups} [3] [Enter] would create these 3 subgroups: (1,2,3,4)
(5,6,7,8) (9,10,11,12).
Spacing
{Jump} is used to skip over a specified number of channels.
[1] [Thru] [1][2]{Chan Per Group} [3] {Jump} [1] [Enter] would create these 3 subgroups
of 3 channels each: (1,2,3) (5,6,7) (9,10,11). Channels 4, 8, and 12 will be jumped over
and will not be in the subgroups.
{Odd} selects only the odd numbered channels.
{Even} selects only the even numbered channels.
{Reorder} is used to reorder the channels of a group into numeric order.
Editing and Updating Groups in Live
Existing groups can be updated or re-recorded in Live. If you re-record an existing group, a con-
firmation is required (unless disabled in Setup). By re-recording a group, you replace the contents of
the group, you do not add to it. Updating a group does not require a confirmation and adds chan-
nels to the group, rather than replacing them.
Other editing or updating examples are:
[Group] [x] [Label] [Label] [Enter] - clears the label.
[Group] [x] [Label] [name] [Enter] - stores a new label.
[1] [Thru] [5] [Update] [Group] [n] [Enter] - adds channel 1-5 to existing Group n.
For record examples, please see Recording Groups Live (on page186).
Multicell Fixtures In Groups
There are multiple different ways to create groups using multicell fixtures.
Note: The following examples are created in the group list. Groups can also be recorded in
Live. See Recording Groups Live (on page186)
To create subgroups of the whole multicell fixtures:
[Group] [3] [1] [Enter] [5] [0] [0] [Thru] [5] [0] [3] [Enter]
To create a group with only the cells of the selected multicell fixtures:
[Group] [3] [2] [Enter] [5] [0] [0] [Thru] [5] [0] [3] [.] [Enter]
To create a group with only certain cells of multicell fixtures:
[Group] [3] [3] [Enter] [5] [0] [0] [Thru] [5] [0] [1] [.] [1] [Thru] [2] [Enter]
To Next Page
Loading...
