278 Ion Operations Manual
{Go To Cue 0} & [Load]
You can use {Go To Cue 0} in conjunction with a fader load button to send a specific cue list to cue 0.
This action does not use the command line. On the desired fader, simply press:
{Go To Cue 0} & [Load]
Using Go To Cue Out
To reset all parameters to their default state (unless they are controlled by a submaster) and reset all
cue lists that are loaded to faders so that the first cue of each list is pending, press:
[Go To Cue] [Out] [Enter]
Note: The [Go to Cue] [Out] command will not affect a cue list that is in Solo Mode (on
page261)
To Next Page
Loading...
