EasyManua.ls Logo

ETC ION - Using {Make Null}

ETC ION
625 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Advanced Manual Control 281
[1][2] [Copy To] [2] [Sneak] <Time> 7 [Enter]
Copies the recorded data from channel 12 to channel 2 and sneaks it in 7 seconds.
Using the {HTP} softkey with [Copy To] will cause any intensity levels to be ignored if they are less
than or equal to the copied value.
For Example:
Channels 1 and 2 are at 50% in cue 10, and in cue 11 channel 1 is at 10% and channel 2 is
at full. If you are in cue 11, and use the syntax:
[1] [Thru] [2] [Copy To] [Cue] [1][0] {HTP} [Enter]
Channel 1 will remain at 50% and channel 2 will go to full.
Using Move To
While technically not a manual control instruction, Move To will be very useful when managing
record target data stored from manual control.
When a Move To command is given, data is removed from its current location and moved to its new
location. If the new location already contains data, a confirmation is required by Ion (unless disabled
in Setup). See Record Defaults (on page143) Existing data in the new location will be completely over-
written if a Move To command is confirmed.
Press [Copy To] [Copy To] to access Move To.
The following are examples of using Move To:
[Color Palette] [1] Move To <Color Palette> [5] [Enter]
[Preset] [3] Move To <Preset> [8] [Enter]
[Cue] [9] Move To <Cue> [2] [Enter]
[Snapshot] [4] MoveTo <Snapshot> [7] [Enter]
[Preset] [1] Move To [Color Palette] [3] [Enter]
[Int Palette] [5] Move To [Preset] [1] [0] [Enter]
When using Move To to convert a preset into a palette, all information not relevant for that palette
will be removed.
Copy To and Move To for Labels, Scenes, and Notes
The [Copy To] and Move To ([Copy To][Copy To]) commands can be used to copy or move labels
between any target types that can have labels. A {Labels Only} softkey will display.
[Sub] [1] [Copy To] [Sub] [3] {Labels Only} will copy submaster 1's label to submaster 2.
Labels, scenes, and notes can be copied or moved between cues. The {Labels Only}, {SceneOnly},
and {Notes Only} softkeys will display.
[Cue] [3] Move To [Cue] [6] {Notes Only} will move the note from cue 3 to cue 6.

Table of Contents

Related product manuals