300 Ion Operations Manual
apply a newly set independent state to the associated fader, or make any changes in blind to an act-
ive cue on stage.
When [Fader Control] {Assert} & [Load] are used together, the entire contents of the cue are
replayed. You can assert just certain elements of a cue by using the command line. See Using Assert
(on page275)
Using Timing Disable
The [Fader Control] {Time Disable} button, used with [Load], causes timing data to be ignored for any
cues that are activated on the associated playback fader. When a playback fader is in timing disable
mode, you will notice “TD” in the associated fader display.
To release the playback fader from time disable mode, press [Fader Control] {Time Disable} & [Load]
again. You can also cut the next cue in by pressing [Fader Control] {Time Disable} & [Go] or the last
cue by pressing[Fader Control] {Time Disable} & [Back].
Note: [Shift] & [Go] and [Shift] & [Back] can be used to cut to the next cue in the same way
as [Timing Disable] & [Go] and [Timing Disable] & [Back].
They will snap from move instruction to the next move instruction in a time of zero, which is the
default time. To set a different time for Timing Disable, go to Setup>User>Manual Control>Timing
Disable. See Manual Control (on page144)for more information.
Using Freeze
{Freeze} can be used to halt all effect activity on any active faders. To activate a freeze for only a spe-
cific fader, press [Fader Controls] {Freeze} & [Load].
There are two ways to remove the freeze command:
press [Fader Controls] {Freeze} &[Load] again for the specific faders to unfreeze the activity.
press {Assert} & [Load] or [Go] or [Stop/Back] for the specific faders to resume the activity.
You may freeze and unfreeze effects from the command line.
[Effect] [2] [Fader Controls]{Freeze} [Enter] - to freeze effect 2. Freezing a specific effect is dif-
ferent from stopping an effect. Freeze will stop the effect exactly where it is.
[Effect] [6] [Thru] [9] [Fader Controls]{Freeze} [Enter] - to freeze a specified range of effects.
When an effect is in freeze mode, you can use the same command to unfreeze:
[Effect] [2] [Fader Controls]{Freeze} [Enter]
[Effect] [6] [Thru] [9] [Fader Controls]{Freeze} [Enter]
Using Stop Effect
The [Fader Control] {Stop Effect} button can be used to stop all effects from operating on any or all
faders, or it may be used with the control keypad to stop a specific effect.
To stop all effects on a fader, press [Fader Control] {Stop Effect} & [Load] of the associated
fader.
To stop a specific effect regardless of the fader it is operating on, press [Fader Control] {Stop
To Next Page
Loading...
