Cue Playback 303
The fader is used to manually complete the cue transition for all parameters. If the fader is operating
in a paired mode, the left fader controls the intensity upfade and all non-intensity parameters, while
the right fader controls all intensity downfade actions. Manual control override automatically
releases when the cue is complete.
A group of faders can be collected for manual override by pressing [Fader Control] {Man Override} &
[Load] (continue adding faders by pressing the associated [Load] buttons).
Releasing Content From a Fader
There are a few ways to release content from a playback fader:
{Off} & [Load] - returns control to the background fader, either a cue or a submaster, and
stops any effects that are running on that fader. If there is no background value, the intens-
ities will just fade out. Press [Fader Control] to see {Off}.
Note: Associated pending and current cues will remain when using {Off} & [Load].
Note: Pressing [Go] will run the cues in their current sequence.
{Release} & [Load] - behaves like {Off} & [Load] except that it sets the pending cue to the first
cue in the list and removes the active cue. Press [Fader Control] to see {Release}.
[Shift] & [Load] - behaves like Release & [Load] except that it additionally removes the content
entirely from the fader. Pressing [Shift] & [Load] on an empty playback fader will unmap the
fader.
[Escape] & [Load] - unmaps all instances of the target (cue list, submaster, palette, or preset)
on a selected fader.
The [Go To Cue] [Out] [Enter]command can be used to fade out all intensities, reset all cue lists to the
top, and to clear out all background LTP fader values.
To Next Page
Loading...
