456 Ion Operations Manual
Physical Address
The physical address is the MAC address. This address is a unique identifier and cannot be modified.
Enable Remote Startup/ Shutdown
It is possible to remotely power on and off some devices, such as RVIs, RPUs, and client desks.
{Remote Startup} and {Remote Shutdown} must be enabled on each device before it can receive the
power on and off commands. The default setting for both is Disabled.
The Remote Power commands are sent from the browser. The command for Power On is sent from
Browser>Network>Power On MultiConsole System, and the command for Power Off is from
Browser>Network>Power Off MultiConsole System.
Note: Only devices that synchronize with the Primary will be available for Remote Power
On and Off.
Network Interface Delay
When {Required} is enabled, the console will wait for the network connection to be fully initialized
before launching the Eos application.
Note: This option is not available on ETCnomad.
When enabled, a launching window will display on start-up. If a network connection is not made,
you will have the option to {Start Anyway}, {Start Offline}, or to {Cancel}.
{Start Anyway} - launches without a network interface. Only User 1 is displayed above the
CIA.
{Start Offline} - starts in offline mode.
{Cancel} - remains in start-up without launching into the Eos application.
Ping
Ping is used to test the network connection between two devices.
Output Protocols
This is for selecting which protocols the desk will output and which ones are included in the default.
To Next Page
Loading...
