458 Ion Operations Manual
Backup Takes Over At Higher Priority
This enables the backup device in a multi-console system to take over at one priority higher than the
master if the master goes offline.
Backup Automatically Takes Control
Switches to the backup automatically if the primary should go offline.
Allowed Output Addresses
A range or ranges of addresses that can be assigned to limit the number of output addresses. The
default setting is to allow addresses 1 through 32767488.
Interface Protocols
MultiConsole
Clicking in the enable box will allow for multiconsole communication on the selected port. See Multi-
console and Synchronized Backup (on page433).
Network Type
This setting adjusts the timeout period before a backup device will take control from the master.
Standard- After five seconds of no response from the master, the backup will assume the mas-
ter has disconnected and will then take control.
Engineered - After 1.6 seconds of no response from the master, the backup will assume the
master has disconnected and will then take control.
File Transfer
This settings adjusts the show file transfer speed between devices. The default setting is Fast File
Transfer.
Note: If you are experiencing connection issues between devices, you can change the set-
ting to Normal File Transfer for a slower transfer speed.
Enable Sensor/ FDX3000 Feedback
Clicking in the enable box will allow your console to receive feedback over the network from a
CEM+, a CEM3, or FDX3000. This option is “Enabled” by default. See [About] Address (on
page361) for more information.
RDM
RDM can be enabled to allow Ion to perform RDM functionality including device discovery.for each
ethernet port on a console. By default, RDMis enabled.
See {Patch} Display and Settings (on page117) and [About] Address (on page361)for more inform-
ation.
Note: RDM requires use of a Net3 Gateway using version 5.1 or higher.
To Next Page
Loading...
