Show Control 483
<Event> [1] [/] {FrameRate} [2] [5] [Enter]
When working in Live, to show the Time Code times in the Cue List, go to the Cue List Display.
[Cue] [Cue]
Select the Cue List to be triggered.
[Cue] [1] [/]
Now associate the Event List to the Selected Cue List.
[Cue] [1] [/] {Execute} {Timecode} {1} [Enter]
Both the Event List and the Cue List are ready for events to be added. There are three ways that
events can be added into the Event List.
Note: You will notice as events are added in the Event List that the time code will display on
the Playback Status Display.
Note: This is the same process for MIDI and SMPTE Time code.
Adding Events from the Show Control Display
Events can be added directly from the show control display, however a new event number must be
specified for each event action.
Open the show control display.
[Displays]><More SK>>{Show Control}
Select the event list.
<Event> [1] [/] [Enter]
Specify a new event number.
<Event> [1] [Enter]
Add the action that the event should execute.
<Event> <1> [Cue] [1] [Enter]
Note: As there is no action softkey, pressing [Cue], [Sub], or [Macro] assumes you are post-
ing to the action field.
Define the time code position of the event.
<Event> <1> [Time] [2][0][1][5] [Enter]
It is possible to enter multiple commands in the same command line. This can speed up your pro-
gramming.
<Event> [2] [Cue] [1.5] [Time] [2][4][1][3] [Enter]
To Next Page
Loading...
