7.3.4.3. Interface Mode
Toggles between 32 Channel mode and 16 Channel Mode. In 32 Channel Mode, the expansion card will
output 32 channels through the Primary DigiLink port. Use this setting if you are connecting directly to
the HD Card to take advantage of all 32 channels. In 16 Channel Mode, the expansion card will output
16 channels through both the primary and secondary port. Use this setting if you are daisy chaining
into another HD interface’s secondary port since the maximum channel count per DigiLink port is 32.
7.3.4.4. Connection Status
Indicates DigiLink port connection status. If GREEN, your PTHD Expansion card is connected to your
HD System. If RED, your PTHD Expansion card is not connected or being detected by your HD System.
Check your connections.
7.3.4.5. Loop Master Status
Indicates whether your H9000 is clock source in the LoopSync or if it is receiving clock externally. If
GREEN, your H9000 is serving as the “Loop Master” to the rest of your HD System. If RED, your H9000
is receiving clock from another source through the LoopSync of your HD System.
7.3.4.6. Clock Control
Allows Pro Tools permission to control your H9000’s internal clock via the HD expansion card. When
using Pro Tools, toggle this on so that your H9000 can sync seamlessly with your HD System’s
clocking. When not using Pro Tools, turn this o so that the H9000 will ignore any clock changes you
make from Pro Tools.
Note
When Clock Control is enabled, you will not be able to change the H9000’s clock settings
regardless of whether the HD expansion card is being used or not. Turn Clock Control o to
change the H9000’s clock settings.
7. Expansion Cards
Copyright © 2021, Eventide Inc.
To Next Page
