Eventide H9000 - Setting up Your H9000 R

 Warning
Please be sure not to interrupt power to your unit during the update process; doing so could
damage its internal rmware, and result in putting the unit into an unbootable state. In the
event this does occur, the H9000 contains a Fail Safe Updater (Section B.2) that can be used to
reinstall the rmware on your H9000.
2.1.11.3. Updating Firmware without an Internet Connection
Refer to Section B.2 Fail Safe Updater / Recovery Mode for information on updating rmware without
an internet connection.
2.2. Setting up Your H9000R
The H9000R lacks front panel controls, so all setup and conguration is done using Emote.
Emote can initially connect to the H9000 in three ways:
Ethernet, directly to the computer.
Ethernet, through your local area network.
Wi-Fi, by using Access Point Mode.
 Note
Emote cannot connect to the H9000 via USB.
.
.
.
38
2. Setup
Copyright © 2021, Eventide Inc.