Eventide H9000 - 2.2. Setting up Your H9000 R

Once a connection to Emote has been established, go to the Devices View (the button labeled 9K in
the menu bar) and locate the H9000 Firmware version at the bottom let corner of the page. Click on
“Updates” and you will be presented with a list of available rmware updates to choose from. Select a
rmware version and click the “Install” button; a pop-up message will conrm that you are updating
your H9000’s rmware. The rst progress bar will indicate that the rmware update le is being
downloaded and sent to the H9000. The second progress bar will indicate that the rmware is being
installed on the H9000 (this will also be reected on the front panel.) Once the rmware update has
been successfully installed, you will be prompted to restart your H9000, which will complete the
update process.
 Note
Update instructions for rmware versions 1.3 and below are detailed in the previous version of
the H9000 User Manual.
2.1.11.2. Firmware Downgrade
In the event that you need to downgrade your H9000’s rmware, the process is the same as
upgrading using either Emote or the oine USB installer. Only one version of each public beta or
production rmware version will be available to choose from. If for any reason you need a specic
rmware version that is not available when upgrading/downgrading, please contact
support@eventide.com and we will provide you with the correct rmware version to install via the
oine USB updater.
 Note
As a precaution against data corruption which could aect system startup, performing a rmware
update will clear the current state of your H9000. It is advised to save your current session
before updating the H9000’s rmware.
2. Setup
37
Copyright © 2021, Eventide Inc.