Press the cursor let/right buttons or use the wheel to highlight the dierent FX chains. Press the
cursor up/down buttons to move through the signal chain blocks in the currently highlighted FX
chains block. An FX chain is comprised of:
Audio inputs
The algorithms contained in the FX chain
Audio outputs
4.4.1. Conguring the Audio Input/Output of your FX Chain
Use the cursor buttons to highlight the Edit block of the FX chain’s audio input section; you will then
be presented with choices for selecting both the physical input connector, and the channel number
of your selected input connector. Use the wheel to scroll through the available choices. When you
have found your desired audio input, press the Enter key. Your chosen input source will now be routed
to the input of the FX chain and the display will show a connecting line.
To assign an output to the FX chain, follow the same procedure using the Edit block located at the
bottom of the FX Chain display.
Note
You cannot select an Output that has been assigned to another FX chain.
4.4.2. Replacing an FX Chain
The middle section of the FX chain block shows the algorithm(s) that make up the current FX chain.
To replace the current FX chain with a dierent FX chain preset:
Highlight the Replace block and press the Enter key. You will be presented with a list of
available FX chain presets.
Navigate to the FX chain preset you wish to use as a replacement then press the Enter key to
insert the chosen preset into the FX chain.
•
•
•
•
•
4. Front Panel Operation
Copyright © 2021, Eventide Inc.
To Next Page
Loading...
