To install an update using a FAT-32 formatted USB ash drive:
Download the “USB Installer for H9000”, which is available on the Eventide website. If for any
reason you need a specic rmware version, please contact support@eventide.com and we will
provide you with the correct USB installer.
Unzip the zip le.
Inside the folder should be 2 les, “usb-updater.sqz” and “usb-updater-info.xml”
Copy these 2 les to the top level of a FAT-32 formatted USB ash drive.
Connect the drive to a USB port on the H9000.
On the H9000:
Power on the unit while holding both the CHECK and X keys for at least two seconds.
Wait for the H9000 to boot into recovery mode.
Follow the on-screen instructions.
On the H9000R:
Power on the unit while inserting a paperclip into the small pinhole that is located to the
right of the front panel Network button. The Network button will start blinking.
If a Wi-Fi dongle is plugged into a USB-A port on the H9000R, it will become visible on your
computer’s list of available Wi-Fi networks as a RECOVERY Access Point once the H9000R’s
Network button stops blinking. Once it becomes visible, connect your computer to it.
If your H9000R is connected directly to your computer or a router via ethernet, you will be
able to connect to the H9000R RECOVERY device in Emote without any further conguration.
When the Network button stops blinking, your H9000R should be visible in Emote, displayed
as the unit’s serial number, followed by the word “recovery.” You can connect to the hardware
as usual, however the options presented in Emote, once connected, will be dierent than
usual. You can access:
The USB updater (if a valid USB device with updater les was connected at boot)
Functions for:
Clear Current State
•
•
•
•
•
•
◦
◦
◦
•
◦
◦
◦
◦
▪
▪
▪
B. Startup Sequences
Copyright © 2021, Eventide Inc.
To Next Page
Loading...
