Eventide H9000 - Page 26

2.1.5.1.2. Internal
In this mode, you set your own tempo, expressed as Beats per Minute (BPM). This BPM value is the
tempo base for any relevant time-based eects. You can set the internal tempo in three dierent
ways:
Tap Tempo: Tap the front panel Tap button at least two times; the H9000 will automatically set
the unit’s internal tempo to the average of the most recent taps, and temporarily display the
tempo in BPM on the display.
TAP AUX SW: Highlight “TAP AUX SW” and press the Enter key to assign an aux switch to Tempo.
Manual Tempo Dial: Highlight the Tempo setting, then adjust the wheel to manually select the
BPM value you wish to set your tempo to.
2.1.5.1.3. MIDI Clock
In this mode, the H9000 will automatically set the tempo to an incoming MIDI signal (as long as that
MIDI signal contains a valid MIDI clock signal). The external MIDI clock signal can arrive either via DIN,
or USB-B.
2.1.5.1.4. DAW
In this mode, the H9000 will automatically sync to your DAW. For this to work correctly, you must be
running Emote as a plug-in in your DAW.
 Note
When tempo mode is set to o, MIDI Clock, or DAW, the tempo dial and tap tempo functions will
be disabled.
•
•
•
2. Setup
25
Copyright © 2021, Eventide Inc.