EverFocus EFC304 - Page 48

NAV IP Access controller

39

5.6.4.10 Card PIN Setting
EachcardintheNAVControllerisassociatedwithan8‐digitPIN.ThePINstatuscanbesetasenabledor
disabledandifenabled,Acardholderisrequiredtoinput thePINeverytimewhenenters/exitthedoorif
thereaderisakeypadreader.
Atthefollowingsubmenu,press toenterPINsetting:

The PIN status of the current card, i.e., enabled or disabled, will be displayed as shown below. Press
totogglebetweentwostatuses.Press toexit.
 

5.6.4.11 Change Card Serial Number
EachcardintheNAV Controllerhas auniqueserialnumber,it canbe modify.Usuallyifthe cardholder
lostthecardanddoesn’twanttoaddanewoneagain,itcanbemodifiedfromtheoldserialnumberto
thenewone.
Atthefollowingsubmenu,press tochangecardID:

ThebelowscreenwillbeshowntopromptuserstoinputnewID.

TheusercaneitherswipethecardthroughasystemreadertogetanewID,orinputitmanually.Press
toconfirmtheinputofnewID.IfinputIDalreadyexists,thesystem
willprompt:
Otherwise,systemwillshowthebelowinformation:


5.6.4.12 Modify card pin
EachcardintheNAVControllersystemisassociatedwithan8‐digitPIN.CardPINcanbe
modifiedfromthebelowscreen.Atthefollowingsubmenu,pressentertoModify
CardPIN.
Mo
d
i
fy PIN
Card Property Updated
Successfully
Card already existe
d
Input new ID:
________
Modify ID
PIN disabled
[ENT] to Toggle
PIN enabled
[ENT] to Toggle
PIN Setting