Evolis Avansia - Page 47

47
4
Warnings and error messages
LCD Display Description Action required
Remove Card:fdr
Remove Card:ip
Remove Card:prtr
Remove Card:mag
There is a card jam. Yes
Remove the cards by rotating the
ejection dial and press the SET Key.
There is a card jam. Yes
Remove the cards by rotating the
Ejection Dial, and press the SET Key.
The feeding roller may be dirty. Yes
Clean the feeding roller.
If the feeding roller is excessively dirty,
clean the printer using a cleaning card.
Call TechSupport An error that requires repair may occur. Yes
Turn off and on the power.
Repairs are necessary if error reoccurs.
Firmw. Dwnld err Program version update was interrupted. Yes
Turn off and on the power, then start
version update again.
Mag: Write Error
Mag: Read Error
Reading / writing of the magnetic data failed. Yes Press the SET Key.
The card set is not in the correct direction.
There is scratches or dirt on the card’s magnetic strip.
The magnetic characteristics of the card do not match the
specications of the magnetic encoder and the settings of the
magnetic encoder.
Yes
Check the loading direction of the
cards.
Use undamaged cards.
Check the specications of the
magnetic encoder.
Chip prt#1:Error
During operation of the IC option 1, data reception by the
computer was interrupted.
Yes Press the SET Key.
Chip prt#2:Error
During operation of the IC option 2, data reception by the
computer was interrupted.
Yes Press the SET Key.
External Box
During operation of the external box, data reception by the
computer was interrupted.
Yes Press the SET Key.