Testing Fibers
Optical Explorer 93
Performing Measurements
To perform measurements:
1. If you want to perform a test with a TestFlow job, ensure that you have
created a job with your TestFlow account from the TestFlow mobile
application or that someone from your organization has created one
for you, and transfer it to your OX1. See Transferring a TestFlow Job to
the OX1 on page 159 for details.
2. Clean the connectors properly.
3. Connect the launch cord or the fiber under test to the OX1 port.
4. On your unit, ensure that the parameters have been set according to
your needs.
5. If necessary, from the main menu, tap Fiber Xplorer.
OR
Under TestFlow, tap the name of the job you have transferred to your
unit.
CAUTION
Ensure that the connector of the launch or receive cord always
matches the connector of the unit (APC or UPC). Joining
mismatched connectors will damage the ferrules.
To Next Page
Loading...