Troubleshooting
Optical Explorer 205
Solving Common Problems
On my unit, no wireless
network is listed.
No network has been
configured yet.
You must first configure the desired
networks on your smart device,
using the OX1 tool in the TestFlow
mobile application (see Working
With a Wireless Network on
page 145).
My unit does not
connect automatically to
the wireless network
that I have used during
my last work session.
There is a connection
problem with the
network.
³ Ensure that the Wi-Fi
connection is enabled on your
unit (see Enabling or Disabling
the Wireless Communication
on page 141).
³ In the case of a secured
network, ensure that the
password has not changed
since the initial configuration of
this network. If the password is
no longer valid, you will have to
update it using the TestFlow
mobile application
(see Working With a Wireless
Network on page 145).
³ Ensure that the network is
working normally.
Problem Possible Cause Solution
To Next Page
Loading...