Installing Power Supply Units in the BlackDiamond 8800 Series Switches
BlackDiamond 8800 Series Switches Hardware Installation Guide
102
Installing an Extreme Networks AC Power Supply
This section describes how to install either of the following Extreme Networks UL-listed accessory
power supply units:
● 700/1200 W AC power supply (Model number 60020/PS 2336)
This power supply is compatible with the BlackDiamond 8806 switch and the BlackDiamond 8810
switch.
● 600/900 W AC power supply (Model number 41050/PS 2431)
This power supply is compatible only with the BlackDiamond 8806 switch.
The power supply bay in the BlackDiamond 8800 series switch can accommodate up to six
hot-swappable AC power supplies.
In a BlackDiamond 8806 system, the 700/1200 W AC power supply can be combined with a
600/900 W AC power supply in the same chassis.
Extreme Networks does not recommended using the 700/1200 W AC power supply with a 1200 W DC power
supply in the same BlackDiamond 8800 series switch.
Required Tools and Equipment
You need the following tools and equipment to install or remove an Extreme Networks AC
power supply:
● Power supply cord (110 V AC, 220 V AC, or applicable to country of use)
An AC power cord is not included with Extreme Networks AC power supplies. You must obtain a
power cord that meets the requirements in “Selecting Power Supply Cords” on page 177. See the
input specifications in Table 27 on page 193.
● Thermal protective gloves (required for removal)
To Next Page
Loading...
