Extreme Networks BlackDiamond 8810 - G48 T I;O Module

BlackDiamond 8800 Series Switches Hardware Installation Guide
31
G48T I/O Module
The G48T I/O module (Figure 14) has 48 autosensing 10/100/1000BASE-T ports that use standard RJ-45
connectors.
Figure 14: G48T I/O Module
In the default configuration of the G48T I/O module, all ports:
● Are added to the default VLAN as untagged
● Inherit the properties of the default VLAN (for example, protocol type and VLANid)
● Operate in autonegotiation mode
The G48T I/O module has the following LEDs:
● Module status
● Module diagnostics
● Port status
For information about the LEDs and their activity on the G48T I/O module, see “I/O Module LEDs” on
page 50.
Module status LEDs
10/100/1000BASE-T
ports
ASP037A