Extreme Networks BlackDiamond 8810 - Leds; Power Supply Cords; Fuse

Power Supplies for BlackDiamond 8800 Series Switches
BlackDiamond 8800 Series Switches Hardware Installation Guide
58
LEDs
The front panel of the 600/900 W AC power supply provides the status LEDs listed in Table 15.
Power Supply Cords
If you use a 110 V AC power supply cord, the maximum DC output power of the power supply is
600 W. If you use a 220 V AC power supply cord, the maximum DC output power of the power supply
is 900 W.
An AC power supply cord is not shipped with the 600/900 W AC power supply. To purchase an AC
power cord, contact your local Extreme Networks Channel Account Manager or Sales Manager, or
purchase a cord from your local supplier. All power supply cords must meet the requirements listed in
“Selecting Power Supply Cords” on page 177.
CAUTION
The 600/900 W AC power supply does not have a switch for turning the unit on and off. Remove the plug
from the electrical outlet to disconnect power to the 600/900 W AC power supply. Make sure that this connection is
easily accessible.
Make sure that the 600/900 W AC power supply circuit is not overloaded. Use proper over-current protection, such
as a circuit-breaker, to prevent over-current conditions.
Fuse
The Extreme Networks 600/900 W AC power supply line and neutral legs are both fused. Power to the
system may still be live if the neutral fuse is open. This is not a field operator replaceable fuse. In the
event of failure, immediately return the Extreme Networks 600/900 W AC power supply for a complete
replacement.
WARNING!
Field operators must not attempt to configure or replace fuses in Extreme Networks 600/900 W AC power
supplies. In the event of failure, immediately return the defective Extreme Networks 600/900 W AC power supply for
a complete replacement.
Table 15: LEDs on the Extreme Networks 600/900 W AC Power Supplies
Power Supply Condition
Power
Green
Predictive
Fail
Amber
Fail
Amber
Power supply AC outputs working normally On Off Off
AC input power present/standby output on Blinking Off Off
Current limit on 48 VDC output On Off Blinking
Predictive failure On Blinking Off
No input power to this power supply only Off Off On
No input power to any power supply Off Off Off
Power supply failure Off Off On