Extreme Networks BlackDiamond 8810 - Installing the Replacement BlackDiamond Fan Tray

BlackDiamond 8800 Series Switches Hardware Installation Guide
157
WARNING!
Be sure that all fan blade motion has ceased before continuing to remove the fan tray.
4 Support the bottom of the fan tray with your free hand as you use the handle to slide the fan tray
completely out from the fan tray slot.
CAUTION
Be sure to support the weight of the fan tray using both hands are used to support the weight of the fan
tray during removal.as you remove the fan tray from the chassis.
Installing the Replacement BlackDiamond Fan Tray
To install a replacement fan tray into the BlackDiamond 8800 series switch:
1 Support the bottom of the fan tray with one hand as you lift the fan tray by the handle using the
other hand.
2 Align the spare fan tray with the fan tray slot on the switch, and then slide the fan tray into place in
the switch (see Figure 114 and Figure 115).
CAUTION
Always use both hands to support the weight of the fan tray during installation.
Figure 114: Installing the Fan Tray in the BlackDiamond 8810 Switch
ASP030A
Fan Tray
Handle
Fan Tray
Captive
Screws (x2)