BlackDiamond 8000 Series Modules
BlackDiamond 8800 Series Switches Hardware Installation Guide
30
10G4X I/O Module
The 10G4X I/O module (Figure 13) has four unpopulated XENPAK-based 10 Gigabit Ethernet ports.
The 10G4X module is not compatible with the 8900-G96Tc module. If a 10G4X module and an
8900-G96Tc module are installed in the same chassis, only one of these modules will function.
Figure 13: 10G4X I/O Module
In the default configuration of the 10G4X I/O module, all ports:
● Are added to the default VLAN as untagged.
● Inherit the properties of the default VLAN (for example, protocol type and VLANid)
The 10G4X I/O module has the following LEDs:
● Module status
● Module diagnostics
● Port status
For information about the LEDs and their activity on the 10G4X I/O module, see “I/O Module LEDs”
on page 50. For information about the XENPAK interfaces, see the Extreme Networks Pluggable Interface
Modules Installation Guide.
Module status LEDs 10 Gbs ports
ASP040A
To Next Page
Loading...
