BlackDiamond AC Power Cord Retainers
BlackDiamond 8800 Series Switches Hardware Installation Guide
138
BlackDiamond 8806 AC Power Cord Retainer
Connect all AC power cords before you install the power cord retainer.
You need a #2 Phillips screwdriver to install or removing the BlackDiamond 8806 AC power cord
retainer:
● ESD-preventive wrist strap
● #2 Phillips screwdriver
Installing the BlackDiamond 8806 AC Power Cord Retainer
To install the BlackDiamond 8806 AC power cord retainer:
1 Starting at the left, insert the plug of each AC power cord into the power connectors on the switch,
and lift each installed power cord over the previous plug (see Figure 95).
Verify that all installed AC power cords are firmly plugged into the power connectors.
Figure 95: Installing and Routing the AC Power Cords
2 Hold the AC power cord retainer as shown in Figure 96.
Figure 96: BlackDiamond 8806 AC Power Cord Retainer
EX_138
Starting at the left, insert each plug
and lift power cord over previous plug
EX_141
Captive screw
Captive screw
To Next Page
Loading...
