Extreme Networks BlackDiamond 8810 - Page 139

BlackDiamond 8800 Series Switches Hardware Installation Guide
139
3 Place the retainer against the switch as shown in Figure 97. Tighten the captive screw at each end of
the retainer.
Figure 97: Securing the BlackDiamond 8806 AC Power Cord Retainer
4 Starting from the left, lay the first four power cords into the retainer (see Figure 98).
5 Lay the last two power cords on top of the bottom four cords (see Figure 98).
Figure 98: Routing the Power Cords in the Retainer
EX_139
Install and secure the channel bracket to
the switch by tightening both captive screws
Captive screw
Captive screw
From the left, lay first four
power cords into channel bracket
Lay last two power cords
onto others