B680H 2 732719 - Rev.E
Translation of the original instructions
ENGLISH
8. TWO-BARRIER CONFIGURATION ..................... 54
8.1 Two opposing barriers ................................ 54
Connecting opposing barriers ....................... 54
Primary / secondary configuration ................... 55
8.2 Two interlocked barriers .............................. 56
Interlock configuration ............................. 56
9. DIAGNOSTICS ........................................ 57
9.1 Display signals ....................................... 57
9.2 Firmware version ..................................... 58
9.3 Automation status.................................... 58
9.4 Error codes and alarms ................................ 59
10. MAINTENANCE ...................................... 60
10.1 Scheduled maintenance ............................. 60
10.2 Topping up the oil ................................... 62
10.3 Air bleeding procedure .............................. 63
10.4 Operational problems ............................... 64
10.5 Reversing the opening direction ...................... 65
11. INSTRUCTIONS FOR USE ............................ 66
11.1 Safety recommendations ............................ 66
11.2 Emergency use ...................................... 67
11.3 Manual operation ................................... 67
Release manoeuvre ................................. 67
Restoring operation ................................ 67
TABLES
1 Technical data ....................................... 9
2 E680S board technical data .......................... 23
3 Basic programming .................................30
4 Advanced programming ............................32
5 Expert Programming ...............................34
6 Default expert programming related to the operating
logic ...............................................38
7 Default parameter
cF - S beam .....................39
8 Default parameter
cF - L beam .....................39
9 Assigning an address to BUS 2easy photocells.........47
10 Addressing BUS 2easy control devices ................48
11 LED diagnostics.....................................57
12 Errors and alarms ...................................59
13 Scheduled maintenance ............................60
14 Periodic replacements ..............................62
15 Troubleshooting ....................................64
16 S beam balancing ..................................69
17 L beam balancing ..................................69
18 Loop windings table ................................70
19 LOOP diagnostics ...................................71
20 Limits of use in relation to wind .....................72
ADDENDUM
1 Foundation (barrier in maximum configuration) ......68
2 Balancing system ...................................69
3 Magnetic loop ......................................70
4 Limits of use in relation to wind .....................72
To Next Page
Loading...
