Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·153·
General machine parameters
NTOOL (P23)
Indicates the number of tools in the tool magazine. On the other hand, the CNC adjusts the length
of the tool table to that value.
NPOCKET (P24)
Indicates the number of pockets in the tool magazine. On the other hand, the CNC adjusts the length
of the tool magazine table to that value.
RANDOMTC (P25)
Indicates whether the tool magazine is random or not.
• On a random magazine, the tools may occupy any position (pocket). If this machine parameter
is set for random magazine, general parameter TOFFM06 (P28) must be set for machining
center.
• On a non-random magazine, the tool always occupies its own pocket. The magazine position
number is the same as the tool number.
In a non-random magazine, the tools must be placed in the tool magazine table in the pre-established
order (P1 T1, P2 T2, P3 T3, etc.). Optionally, general parameter TOOLMATY (P164) may be used
to assign several different tools to each tool position. In this case, the magazine position number
may be different from the tool number.
TOOLMONI (P26)
Selects the display units of the tool’s nominal and real lives.
NTOFFSET (P27)
Indicates the number of tool offsets available in the tool offset table. On the other hand, the CNC
adjusts the length of the tool offset magazine table to that value.
TOFFM06 (P28)
Indicates if the machine is a machining center.
Possible values
Integer numbers between 0 and 255.
Default value: 100
Possible values
Integer numbers between 0 and 255.
Default value: 100 (for the M model)
Default value: 0 (for the T model)
Value Meaning
YES It is a random tool magazine.
EZ It is not a random tool magazine.
Default value: EZ
Value Meaning
0 Tool life in minutes
1 Tool life in number of operations.
Default value: 0
Possible values
Integer numbers between 0 and 255.
Default value: 100
To Next Page
Loading...
