·154·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
General machine parameters
If it is, the CNC will select, at the tool magazine, the tool indicated when executing the "T" function
and it will be necessary to execute M06 afterwards in order to carry out the tool change.
It is recommended to associate he subroutine corresponding to the tool changer with the M06.
NMISCFUN (P29)
Indicates the number of M functions available in the M function table.
MINAENDW (P30)
Indicates the minimum time period that the AUXEND signal must remain activated so the CNC will
interpret it as a valid signal. AUXEND is a PLC signal which indicates to the CNC that functions M,S
or T have been executed.
If the corresponding M function has been set in the M table not to wait for the AUXEND signal, the
time period indicated in this parameter will be the duration of the MSTROBE signal.
See "7.8 Auxiliary M, S, T function transfer" on page 342.
Value Meaning
YES Yes, it is a machining center.
EZ It is not a machining center.
Default value: EZ
Possible values
Integer numbers between 0 and 255.
Default value: 32
Possible values
Integers between 0 and 65535 ms.
Default value: 100
To Next Page
Loading...
