Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·159·
General machine parameters
MOVAXIS3 (P58)
Used in the third cross compensation table, it indicates the axis causing position variations on
another axis. The definition code is:
COMAXIS3 (P59)
Used in the third cross compensation table, it indicates the axis suffering the position variations
caused by another axis. The compensation is applied onto this axis. The definition code is:
TOOLSUB (P60)
Indicates the number of the subroutine associated with the tools. This subroutine will be executed
automatically every time a T function is executed.
CYCATC (P61)
This parameter must be used when having a machining center, general parameter TOFFM06 (P28)
= YES.
Indicates whether a cyclic tool changer is being used or not.
A "cyclic tool changer" is an automatic tool changer which requires an M06 command (tool change)
after searching for a tool and before searching for the next one.
With a non-cyclic tool changer, it is possible to search for several tools in a row without necessarily
having to make the actual tool change (M06 function).
Value Meaning Value Meaning
0 None. 5V axis.
1X axis. 6W axis.
2Y axis. 7A axis.
3Z axis. 8B axis.
4U axis. 9C axis.
Default value: 0 (none)
Value Meaning Value Meaning
0 None. 5V axis.
1X axis. 6W axis.
2Y axis. 7A axis.
3Z axis. 8B axis.
4U axis. 9C axis.
Default value: 0 (none)
Sample
If NPCROSS3=25, MOVAXIS3=3 and COMAXIS=4, the CNC will allow access to the third cross
compensation table.
Each one of these 25 points (NPCROSS3) of this table will indicate the X position value and the error suffered
by the U axis when the Z axis is positioned at this point.
This way, the CNC will apply this compensation onto the U axis.
Possible values
Integer numbers between 0 and 9999.
Default value: 0 (none)
Value Meaning
YES It is a cyclic changer.
EZ It is not a cyclic changer.
Default value: YES
To Next Page
Loading...
