·158·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
General machine parameters
NPCROSS2 (P54)
Indicates the number of points available in the second cross compensation table.
This compensation is used when the movement of one axis causes a position change on another
axis. The CNC offers a table where one could enter the position variations of one axis for the
particular positions of the other axis.
MOVAXIS2 (P55)
Used in the second cross compensation table, it indicates the axis causing position variations on
another axis. The definition code is:
COMAXIS2 (P56)
Used in the second cross compensation table, it indicates the axis suffering the position variations
caused by another axis. The compensation is applied onto this axis. The definition code is:
NPCROSS3 (P57)
Indicates the number of points available in the third cross compensation table.
This compensation is used when the movement of one axis causes a position change on another
axis. The CNC offers a third table where one could enter the position variations of one axis for the
particular positions of the other axis.
Possible values
Integer numbers between 0 and 255.
Default value: 0 (none)
Value Meaning Value Meaning
0 None. 5V axis.
1X axis. 6W axis.
2Y axis. 7A axis.
3Z axis. 8B axis.
4U axis. 9C axis.
Default value: 0 (none)
Value Meaning Value Meaning
0 None. 5V axis.
1X axis. 6W axis.
2Y axis. 7A axis.
3Z axis. 8B axis.
4U axis. 9C axis.
Default value: 0 (none)
Sample
If NPCROSS2=15, MOVAXIS2=2 and COMAXIS2=8, the CNC will allow access to the second cross
compensation table.
Each one of these 15 points (NPCROSS2) of this table will indicate the X position value and the error suffered
by the B axis when the Y axis is positioned at this point.
This way, the CNC will apply the compensation of the Y axis table on to the B axis.
Possible values
Integer numbers between 0 and 255.
Default value: 0 (none)
To Next Page
Loading...
