Fagor CNC 8055i FL EN - Page 157

Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·157·
General machine parameters
PRBMOVE (P46)
Indicates the maximum distance the tool can travel when calibrating it with a probe in JOG mode.
USERDPLY (P47)
Indicates the number of the user program associated with the execution mode. This program will
be executed via the user channel when pressing the softkey USER in the EXECUTE mode.
USEREDIT (P48)
Indicates the number of user program associated with the Edit mode. This program will be executed
via the user channel when pressing the softkey USER in the EDIT mode.
USERMAN (P49)
Indicates the number of the user program associated with the JOG mode. This program will be
executed via the user channel when pressing the softkey USER in the JOG mode.
USERDIAG (P50)
Indicates the number of the user program associated with the Diagnosis mode. This program will
be executed via the user channel when pressing the softkey USER in the DIAGNOSIS mode.
ROPARMIN (P51) ROPARMAX (P52)
They indicate the upper limit "ROPARMAX " and lower limit "ROPARMIN" of the global arithmetic
parameter group (P100-P299), user arithmetic parameters (P1000-P1255) or OEM arithmetic
parameters (P2000-P2255) to be write-protected. There are no restrictions to read these
parameters.
The parameters write-protected from the CNC may be modified from the PLC.
PAGESMEM (P53)
Not used.
Possible values
Between 0.0001 and 99999.9999 millimeters.
Between 0.00001 and 3937.00787 inches.
Default value: 50 mm.
Possible values
Integer numbers between 0 and 65535.
Default value: 0 (none)
Possible values
Integer numbers between 0 and 65535.
Default value: 0 (none)
Possible values
Integer numbers between 0 and 65535.
Default value: 0 (none)
Possible values
Integer numbers between 0 and 65535.
Default value: 0 (none)
Possible values
Integer numbers between 0 and 9999.
Default value: 0 (it is not protected)