·162·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
General machine parameters
• At the beginning of the compensation, the tool should be positioned before penetrating into the
part. The additional block must be executed in the upper plane and, consequently, together with
the first block (COMPTYPE=00).
• At the end of the compensation, the tool should withdraw from the part without penetrating into
it. The additional block must be executed in the upper plane and, consequently, together with
the second block (COMPTYPE=10).
(hundreds) Activate the compensation in the first motion block.
The hundreds indicate whether the compensation is activated in the first motion block or not, even
if the plane axes are not involved. The same criteria also applies when turning the compensation off.
After activating the compensation, it could happen that the plane axes do not get involved in the first
motion block either because they have not been programmed or because the same point as the tool
position has been programmed or because a null incremental move has been programmed. In this
case, the compensation is applied in the current tool position; depending on the first movement
programmed in the plane, the tool moves perpendicular to the path on its starting point.
Value Meaning
0xx The compensation is activated in the first block having a movement of the plane axes.
1xx The compensation is activated in the first motion block even if there is no movement of
the plane axes.
Default value: 000
To Next Page
Loading...
