Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·163·
General machine parameters
The first movement programmed in the plane may be either linear or circular.
FPRMAN (P75)
It is only used on lathe model CNC's and it indicates whether feedrate per revolution is permitted
or not.
MPGAXIS (P76)
It is only used on the Lathe model CNCs and it indicates which axis the handwheel is assigned to.
It is set according to the following codes:
DIRESET (P77)
It is used on the lathe model CNC. It indicates whether the RESET is effective with or without a
previous CYCLE STOP.
If DIRESET=YES, the CNC first carries out an internal CYCLE STOP to interrupt program execution
and, then, executes the RESET.
Obviously, if it is performing a threadcutting or similar operation, not admitting a CYCLE STOP, it
will wait for the operation to be concluded before interrupting the program.
· · ·
G90
G01 Y40
G91 G40 Y0 Z10
G02 X20 Y20 I20 J0
· · ·
(X0 Y0)
Y
X
· · ·
G90
G01 X-30 Y30
G01 G41 X-30 Y30 Z10
G01 X25
· · ·
(X0 Y0)
Y
X
Example of beginning of compensation (COMPTYPE=1x1)
Value Meaning
YES Admitted.
EZ Not admitted.
Default value: EZ
Value Meaning Value Meaning
0 None. 5V axis.
1X axis. 6W axis.
2Y axis. 7A axis.
3Z axis. 8B axis.
4U axis. 9C axis.
Default value: 0 (shared)
Value Meaning
YES The CNC accepts the RESET any time.
EZ Only if the STOP condition occurs.
Default value: EZ
To Next Page
Loading...
