Fagor CNC 8055i FL EN - Page 164

·164·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
General machine parameters
PLACOMP (P78)
It is used on the lathe model to indicate whether there is tool compensation in all planes or just in
the ZX plane.
When "PLACOM = 1", the CNC interprets the tool table as follows:
MACELOOK (P79)
When using "Look-Ahead" the operator sets the percentage of acceleration being applied in Look-
Ahead by means of function G51.
With general parameter MACELOOK (P79) the OEM can limit the maximum percentage of
acceleration that the user may set with G51.
MPGCHG (P80) MPGRES (P81) MPGNPUL (P82)
These parameters must be used when having an electronic handwheel to jog the axes.
MPGCHG (P80)
General parameter MPGCHG (P80) indicates the turning direction of the electronic handwheel. If
correct, leave it as is. Otherwise, select YES is there was a NO before or vice versa.
MPGRES (P81)
General parameter MPGRES (P81) indicates the counting resolution of the electronic handwheel
and depends on the display format selected for the corresponding axis parameter DFORMAT (P1).
Value Meaning
0 Only in the ZX plane.
1 In all planes..
Default value: 0
ZX plane WX plane
The Z and K parameters, with the abscissa axis Z axis W axis
The X and I parameters, with the ordinate axis X axis X axis
Possible values
Integer numbers between 0 and 255.
Default value: 0 (there is no limit)
Possible values
NO / YES.
Default value: EZ
Possible values
0, 1 and 2.
Default value: 0
Format Resolution
DFORMAT (P1) MPGRES=0 MPGRES=1 MPGRES=2
5.3 mm
4.4"
0,001 mm
0.0001"
0,010 mm
0.0010"
0,100 mm
0.0100"
4.4 mm
3.5"
0.0001 mm
0.00001"
0.0010 mm
0.00010"
0.0100 mm
0.00100"
6.2 mm
5.3"
0.01 mm
0,001"
0.10 mm
0,010"
1.00 mm
0,100"