Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·189·
General machine parameters
STPFILE (P146)
It defines the number of the program where the oscilloscope configuration will be saved. This
program will be saved in the hard disk (KeyCF).
CODISET (P147)
This parameter is associated with the MC / TC work mode.
This parameter has 16 bits counted from right to left.
Each bit has a function or work mode associated with it. By default, all the bits will be assigned the
value of ·0·. Assigning the value of ·1· activates the corresponding function.
Bit 0. There are auxiliary M functions in the cycles of the MC work mode.
This bit indicates whether the operations or cycles have (bit=1) or not (bit=0) auxiliary M functions
associated with roughing and finishing operations.
If the auxiliary M functions are enabled for the roughing and finishing operations of the cycles, a
window is displayed where up to 4 auxiliary M functions can be defined. These functions are
executed at the beginning of the operation (roughing or finishing) where they have been defined.
Bit 1. It is not possible to access the cycles or the programs from the auxiliary screen.
This bit indicates whether it allows (bit=0) or not (bit=1) access the cycles and programs from the
auxiliary screen. With restricted access, the program selected for execution cannot be removed
either with [CLEAR].
Bit 2. The CNC is configured as having two and a half axes (MC model).
This bit indicates whether the CNC is configured as two and a half axes (bit=1) or not (bit=0).
A two-and-a-half-axis configuration is a milling machine where the X and Y axes are motorized and
the Z axis is set as a DRO axis (display only). In this configuration, the Z axis is moved manually.
Possible values
Integer numbers between 0 and 65535.
Default value: 0
Bit Meaning
0 There are auxiliary M functions in the cycles.
1 It is not possible to access cycles or programs from the auxiliary screen.
2 The CNC is configured as having two and a half axes.
3 - 4 Not used.
5 Plane change option.
6 It shows the coolant icon.
7 It enables the option to select roughing or finishing.
8 Enables the possibility of defining the thread pitch as number of threads per inch.
9 It enables the option to program variable-pitch threads.
10 It enables the option for zig-zag flank penetration (lathe only).
11 It enables the option for partial thread repair (lathe only).
12 It enables the option for partial thread repair (lathe only).
13 Enables manual tool calibration without stopping the spindle (for lathe only).
14 - 15 Not used.
Default value in all the bits except bit 7: 0
Default value of bit 7: 1
bit
15
14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
To Next Page
Loading...
