·190·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
General machine parameters
The interface and the machining cycles are adapted for this type of configuration. Since not all the
cycles are applicable to a two-and-a-half-axis configuration, it will be necessary to set parameters
COCYZ, COCYF1 and COCYF5 to hide them.
Bit 5. It enables the plane change option (MC model).
This bit indicates whether the plane change option of the programming assistance of the MC model
is enabled (bit=0) or disabled (bit=1).
Bit 6. It shows the coolant icon (MC/TC models).
This bit indicates whether the coolant icon is displayed (bit1=0) or hidden (bit1=1) in the cycles of
the MC/TC model.
Bit 7. It enables the option to select or unselect roughing or finishing.
This bit indicates whether the roughing or finishing operation may be selected (bit=1) or not (bit=0).
Bit 8. Enables the possibility of defining the thread pitch as number of threads per inch.
This bit enables (bit=0) or disables (bit01) the option to define the thread pitch as number of threads
per inch.
The number of threads per inch can only be entered when not working with any particular thread
defining system; i.e. when using a FREE system.
Bit 9. It enables the option to program variable-pitch threads.
This bit enables (bit=0) or disables (bit=1) the option to program variable-pitch threads.
Bit 10. It enables the option for zig-zag flank penetration (lathe only).
This bit enables (bit=0) or disables (bit01) the option to penetrate in zig-zag by the flanks in lathe
type threading cycles.
Bit 11. It enables the option for partial thread repair (lathe only).
This bit enables (bit=0) or disables (bit01) the option for thread repair in lathe type threading cycles.
Bit 12. It enables the option for partial thread repair (lathe only).
This bit enables (bit=0) or disables (bit01) the option for multiple-entry thread repair in lathe type
threading cycles.
Bit 13. Enables manual tool calibration without stopping the spindle (for lathe only).
This bit enables (bit=0) or disables (bit=1) the manual tool calibration without stopping the spindle.
COCYF1 (P148) COCYF2 (P149) COCYF3 (P150)
COCYF4 (P151) COCYF5 (P152) COCYF6 (P153)
COCYF7 (P154) COCYZ (P155) COCYPOS (P156)
COCYPROF (P157) COCYGROO (P158) COCYZPOS (P159)
In the TC and MC work modes, it allows hiding the operations or cycles not being used showing
only the desired ones.
Each parameter is associated with an operation or cycle and each one of their bits refers to each
available level.
This parameter has 16 bits counted from right to left.
By default, all the bits will be assigned the value of ·0· (option available). Assigning the value of ·1·
hides the level of the corresponding cycle.
Setting of a CNC configured as two-and-a-half axes.
Since not all the cycles are applicable to a two-and-a-half-axis configuration, it will be necessary
to set parameters COCYZ, COCYF1 and COCYF5 as follows.
bit
15
14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
To Next Page
Loading...
