Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·215·
Axis parameters
The best adjustment is achieved when the following error is minimized as much as possible, but
without changing its sign, maintaining the moving direction of the axis.
LOOPCHG (P26)
Indicates the sign of the velocity command. If correct, leave it as is, but to change it, select YES if
it was set to NO and viceversa.
MINANOUT (P27)
Indicates the minimum velocity command for the axis.
The scale for the following error is 10m per square.
• Proper adjustment with Feed-forward.
• Wrong adjustment with Feed-forward.
Possible values
NO / YES.
Default value: EZ
When controlling two axes with a single servo drive, the direction of the analog command must be set
on both axes.
Possible values
It is given in D/A converter units and it admits integer values between 0 and 32767 which corresponds
to an analog command of 10V.
Default value: 0
MINANOUT Minimum velocity command
1
- - -
3277
- - -
32767
0.3 mV.
- - -
1 V.
- - -
10 V.
To Next Page
Loading...
