·216·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
Axis parameters
SERVOFF (P28)
Defines the velocity command offset value for the drive.
BAKANOUT (P29)
Additional analog pulse to recover possible leadscrew backlash in movement reversals.
Every time the movement is inverted, the CNC will apply to that axis the velocity command
corresponding to the movement plus the additional velocity command pulse set in this parameter.
This additional velocity command will be applied for a period of time indicated in the axis parameter
BAKTIME (P30).
BAKTIME (P30)
It indicates the duration of the additional velocity command pulse to make up for backlash in
movement reversals.
DECINPUT (P31)
Indicates whether or not this axis has a home switch for machine reference search.
Possible values
It is given in D/A converter units and it admits integer values between 0 and ±32767 which corresponds
to an analog command of 10V.
Default value: 0 (not applied)
SERVOFF Command
-32767
- - -
-3277
- - -
1
- - -
3277
- - -
32767
-10 V.
- - -
-1 V.
- - -
0.3 mV.
- - -
1 V.
- - -
10 V.
Possible values
It is given in D/A converter units and it admits integer values between 0 and 32767 which corresponds
to an analog command of 10V.
Default value: 0 (not applied)
BAKANOUT Additional velocity command
1
- - -
3277
- - -
32767
0.3 mV.
- - -
1 V.
- - -
10 V.
Possible values
Integers between 0 and 65535 ms.
Default value: 0
Value Meaning
EZ It has no home switch.
YES It has a home switch.
Default value: YES
To Next Page
Loading...
